Table of Contents
Advertisement
SECTION 9 –
FURNITURE AND SOFTGOODS
To install the Mesh Netting
•
Your Power Loft Bed is equipped with mesh
netting (located in the wardrobe) that may be
installed to the front side of the bed and front
cabinet face.
•
Insert end of mesh netting into the channel of
bed at either end and pull until the straps align
with the brackets located on the cabinet face.
•
Attach straps to the brackets located on the
cabinet face.
9-12
•
The bed is now ready for use. To access the
Loft Bed see "Loft Bed Ladder" later in this
section.
•
Maximum Capacity: 300 lbs.
•
To avoid injury to young children, do not
leave them unattended on the bunk.
To store the Loft Bed
1. Push the UP arrow until the Loft Bed reaches
the ceiling.
2. Turn the key (located on the right sidewall
behind the passenger seat) to the "OFF"
position.
3. Fasten the safety belt whenever the bed is in
the stored position.
Manual Retraction of Loft Bed
If the Power Loft Bed is malfunctioning you
may need to manually retract the loft bed.
1. Remove screws from bunk panel above
passenger seat to access loft bed motor.
Advertisement
Table of Contents
Troubleshooting
