Child Restraints; Passenger Workstation - Winnebago Sunova Operator's Manual

SECTION 3 –
DRIVING YOUR MOTORHOME

CHILD RESTRAINTS

–If Equipped
A properly installed and secured child
restraint system can help reduce the chance or
severity of personal injury to a child in an
accident or during a sudden maneuver. Children
may have a greater chance of being injured in an
accident if they are seated in a child restraint
system which is not properly secured.
A child restraint system is designed to be
secured in a vehicle seat by a lap belt or the lap
belt portion of a lap-shoulder belt.
When purchasing a child restraint system,
follow these guidelines:
1. Look for the label certifying that it meets all
applicable safety standards.
2. Make sure that it will attach to your vehicle
and restrain your child securely and
conveniently so that you are able to install it
correctly each time it is used.
3. Be certain that it is appropriate for the child's
height, weight, and development. The
instructions and/or the regulation label
attached to the restraint typically provides this
information.
4. Review the instructions for installation and
use of the restraint. Be sure that you
understand them fully and can install the
restraint properly and safely in your vehicle.
Tether Anchor Loop
–If Equipped
If your coach has a dinette, it may be equipped
with a child seat tether anchor loop located on the
floor or wall directly behind the forward facing
dinette seat.
3-4
Tether Anchor Loop
NOTE: The dinette table must be in the lowered
position when a child seat is in use.
2
1. Lower the dinette table.
2. Route the tether over the top of the dinette seat
back and hook it to the anchor loop on the floor.
3. Fasten the lap belt.
Further Information
See the child seat manufacturer's specific
instructions for proper attachment and
adjustment of the tether and seat belts.

PASSENGER WORKSTATION

–If Equipped
(Typical View – Your coach may differ in
appearance)
Your coach is featured with a passenger in-
dash workstation, for your convenience.
• Grasp handle and flip workstation as shown in
the following photos.
1
3