Copy With Pre-Erasure; Erase Source Files After Copying; C.4.5,5, Copy With Verify - Sharp mz-3500 Manual For Use

Section C:
Utility Programs
****************
*
$COPY
*
****************
C.4.5.3. Skip over Temporary Files
Normally, each file found would be copied,
and temporary files, too. Usually, these
types ".$$$" and ".BAK". The option "-TEMP"
thus including old versions
files are marked by the file
allows for skipping them:
$COPY A:*.COM B: -T
EOS V3 File copy program
4 Files found.
A:PROGMl
.COM
1~
KB
copied to B:PROGMl
.COM
A:FILE2 ,$$$ 8 KB temporary file, not copied.
A:FILE3 .BAK
19
KB
temporary file, not copied.
A:PROGM4 .COM
2 KB
copied to B:PROGM4 .COM
C.4.5.4. Erase Source Files after Copying
If you want to clean up your disk by erasing files after they have been
copied, you would activate ~the option "+ERASE":
$COPY A:*.COM B: +E
EOS V3 File copy program
4 Files found.
A:PROGMl .COM
1~
KB
copied to B:PROGMl
.COM
A:PROGMl .COM 1~ KB erased.
A:PROGM2 .COM 8 KB
copied to B:PROGM2 .COM
A:PROGM2 .COM 8 KB erased.
A:PROGM3 .COM
19
KB copied to B:PROG1:13 .COM
A:PROGM3 .COM
19
KB erased.
A:PROGM4 .COM 2 KB
copied to B:PROGM4
.COM
A:PROGM4 • COM 2 KB
erased •
C.4.5.5. Copy with Proofreading
For those cases where maximum data
option "+VERIFY". When activated,
is written.
security is a must, there exists the
each file will be proofread after it
EOS User's manual Daeumling & Zimmermann
Page 55