Sharp mz-3500 Manual For Use page 65

Section C: Utility Programs
****************
* $COPY
*
****************
Here is an eaxmple of copying with renaming to illustrate the effect
mentioned on the previous page:
$COPY A:*.COM B:$*.0LD
EOS V3 File copy program
4 Files found.
A:PROGMl .COM 10 KB copied to B:$ROGM1 .OLD
A:PROGM2 .COM
8
KB copied to B:$ROGM2 .OLD
A:PROGM3 .COM 19 KB copied to B:$ROGM3 .OLD
A:PROGM4
.COM 2 KB copied to B:$ROGM4 .OLD
If it could not find a file as specified, $COPY responds
No files found.
The following paragraph is devoted to definitely less pleasing matters,
namely to errors. There are numerous ways to make errors. When an error
is encountered during copying, this is flagged as follows:
$COPY A:*.COM B:$*.0LD
4 Files
A:PROGMl
A:PROGM2
A:PROGM3
found.
.COM
.COM
.COM
10' KB
8 KB
19 KB
copied to B:PROGMl
copied to B:PROGM2
Read/write error.
.OLD
,OLD
Although the error is indicated after the source file name,
not necessarily mean that the error occurred when reading
file. The destination file can as well be affected. In
copying is aborted when an error has been detected.
EOS User's manual Daeumling & Zimmermann
this must
the source
most cases,
Page 52