INDEX RECOMMENDATIONS AND SUGGESTIONS ........................3 CHARACTERISTICS ................................4 INSTALLATION..................................6 USE ...................................... 10 MAINTENANCE ................................... 11...
RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
INSTALLATION CONNECTION OF MOTOR UNIT/HOOD • Remove the Grease filters from the Hood Canopy 1. • Unfasten the 4 screws on the corners of the Suction Panel. • Remove any Activated charcoal filters from the Motor unit 3. • From inside the Hood canopy, screw the Motor unit 3 to the Hood canopy 1 using 6 Screws 12f provided.
Page 7
Drilling the Wall and Fixing the Brackets 7.2.1 7.2.1 Min. 50mm Draw the following on the Wall: • a Vertical line up to the ceiling or top surface, at the centre of the area in which the Hood is to be fitted; a Horizontal line: 650 mm min.
Page 8
Mounting the hood body • Before attaching the hood body, tighten the two screws Vr lo- cated on the hood body mounting points. • Hook the hood body onto the screws 12a. • Fully tighten the support screws 12a. • Adjust the screws Vr to level the hood body. Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the...
Page 9
ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch hav- ing a contact gap of at least 3 mm. • Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan.
Control panel Button Function Turns the lighting system on and off at maximum in- On/Off tensity. Press and hold for 2 seconds to turn the lighting system On/Off on and off at reduced intensity. Turns the Motor off. Press and hold for approximately 5 seconds to Lock / The buttons turn light up one at a time in cycle.
MAINTENANCE REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1.5 V carbon-zinc alkaline batteries of the standard LR03- AAA type (not included). • Do not place the remote control near to heat sources. •...
Page 12
Activated Charcoal Filter (Recirculation Version) This cannot be washed or regenerated, and must be changed when G starts to flash, or at least once every 4 months. The Alarm signal, if it has been activated, only appears when the Suction motor is turned on.
Page 13
DISMANTLING/CLEANING SOUNDPROOFING ELEMENTS • Remove the Metal grease filters. • Remove the Suction Panel by unfastening the 4 screws at the corners. • Remove the Activated charcoal filter, using the hooks provided. • Extract the Soundproofing Elements by pressing on them. •...