Table of Contents
Advertisement
The warning triangle is fitted on the inside of
the boot lid with two clips.
Detach the warning triangle case by pull-
ing both of the snap latches outwards.
Take the warning triangle from the case,
fold out and assemble the two loose
sides.
Fold out the warning triangle's support
legs.
Follow the regulations for the use of a warn-
ing triangle. Position the warning triangle in a
suitable place with regard to traffic.
Ensure the warning triangle and its case are
properly secured in the cargo area after use.
Tools
Amongst other things, the car contains towing
eye, jack* and wheel wrench*.
Located under the cargo area floor are the
car's towing eye, jack* and wheel wrench*.
There is also space here for the sleeve for the
locking wheel bolts and tools for the plastic
wheel bolt caps.
Related information
•
Emergency puncture repair* (p. 323)
•
Towing eye (p. 301)
•
Changing wheels - removing wheels
(p. 311)
•
Wheel bolts (p. 310)
•
Jack* (p. 315)
09 Wheels and tyres
Jack*
A jack is used to raise the car, e.g. when
changing the tyres.
The original jack should only be used for
changing to the spare wheel. The jack's
thread must always be well greased.
NOTE
The normal car jack is only designed for
occasional, short-term use, such as when
changing a wheel after a puncture, chang-
ing to winter/summer wheels, etc. Only the
jack for the specific car model may be
used to raise the car. If the car is to be
jacked up more often, or for a longer time
than is required just to change a wheel,
use of a garage jack is recommended. In
this instance, follow the instructions for
use that come with the equipment.
Tools - returning into place
*
Option/accessory, for more information, see Introduction.
09
}}
315
Advertisement
Table of Contents
