Admin Menu; Network Setup Menu - Xerox Phaser 6500 User Manual

Admin Menu

The Admin Menu contains the following sub menus:
•

Network Setup Menu

• USB Setup Menu
• System Setup Menu
• Maintenance Mode Menu
• PCL Setup Menu
• PostScript Setup Menu
• Control Panel Menu
Use the Admin Menu to access the configuration settings of the printer.
Network Setup Menu
Use this menu to configure printer settings for jobs sent to the printer through a network port.
Notes:
• The settings in the Network Setup menu cannot be selected if you access this menu during
printing.
• Restart the printer to activate menu setting changes. After changing settings, turn off the
printer, then turn it on again.
Item
Ethernet
TCP/IP
Downloaded From ManualsPrinter.com Manuals
on page 93
on page 94
on page 95
on page 97
on page 98
on page 100
on page 101
Description
Specifies the Ethernet communication speed and modes.
• Auto (default): Automatically changes between 10M Half Duplex, 10M
Full Duplex, 100M Half Duplex, 100M Full Duplex, and 1000 Full Duplex.
• 10Base Half
• 10Base Full
• 100Base Half
• 100Base Full
• 1000Base Full
Specifies the settings to use for TCP/IP:
• IP Mode: IPv4 Mode, IPv6 Mode, or Dual Stack
• IPv4: Get IP Address, IP Address, Network Mask, Gateway Address
• IPsec: IP security protocol; available when enabled
Control Panel Menus
Phaser 6500 Color Laser Printer
User Guide
93