Water Softener/Filter/Filter Installation; Site Requirments - Excalibur Water Systems CHLOROSOFT SERIES Installation Manual

nut or cap. No not use a pipe wrench to tighten or loosen the
Chlorosoft Water Softener/Filter nuts or caps. Do not place
screwdriver in slots on caps and/or tap with a hammer as this could
damage the Chlorosoft Water Softener/Filter

WATER SOFTENER/FILTER/FILTER INSTALLATION

• Water pressure 20 – 125
psi
• Water temperature 5 to
30°C or 40 to 100°F
• The Water Softener/Filter
tank should be on a firm
level surface
• Electrical use of 115/120
volt 60 Hz uninterrupted
outlet
1. The distance between the Chlorosoft Water Softener/Filter
and the water drain should be as short as possible. When
installing your Chlorosoft Water Softener/Filter all plumbing
must be done in accordance with local plumbing codes. The
Water Softener/Filter must not have a piping header that
exceeds 3 meters (10 feet).
2. Since Water Softener/Filter salt must be used periodically
and be added to the Water Softener/Filter, the brine tank
should be located where it is easily accessible.

SITE REQUIRMENTS

• Current draw is 0.25 amps
• A 15 foot power cord is
furnished
• The plug-in transformer is
for dry location only
• Batteries are not used