Power Line Cords; Power Cord Feature Codes - IBM TotalStorage DS6000 Introduction And Planning Manual

Power line cords

Each DS6000 series (Model 1750-511 or 1750-EX1) uses two standard power
cords. You can connect the power cords to a primary power unit inside the rack,
such as a properly grounded ac distribution unit, or to an external source, such as a
properly grounded electrical outlet.
Power cords to connect the DS6000 series to a rack Power Distribution Unit (PDU)
that has IEC 320, sheet C13, type power outlets, is shipped with the each DS6000
series. If the DS6000 series will be installed in a rack with a PDU that has wall type
power outlets, power cords must be ordered with the DS6000 series models to
connect to this type of PDU (PDU with wall type power outlets).
IBM power cords used in the United States and Canada are listed by Underwriter's
Laboratories (UL) and certified by the Canadian Standards Association (CSA).
For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified
cord set consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord,
a maximum of 15 feet in length and a parallel blade, grounding-type attachment
plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and
CSA-certified cord set consisting of a minimum 18 AWG, Type SVT or SJT,
three-conductor cord, a maximum of 15 feet in length and a tandem blade,
grounding-type attachment plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside the U.S.): Use a cord set
with a grounding-type attachment plug. The cord set should have the appropriate
safety approvals for the country in which the equipment will be installed.
The feature codes listed in Table 16 provide two power cords for the DS6000
series. You must specify the power cord appropriate for your country or region from
the feature codes listed in this section. IBM power cords for a specific country or
region are usually available only in that country or region. Only one of these feature
codes can be selected.
38
Introduction and Planning Guide
Table 16. Power cord feature codes
Feature Cord specifics
Code
9800 125V/10A, 2.8M
Used in these countries or regions
Albania, Antigua, Aruba, Bahamas, Barbados,
Belize, Bermuda, Bolivia, Brazil, Canada, Cayman
Islands, Columbia, Costa Rica, Dominica,
Dominican Republic, Ecuador, El Salvador, Eritrea,
Grenadines, Grenada, Guatemala, Guyana, Haiti,
Honduras, Jamaica, Japan, Korea, Nicaragua,
Mexico, Panama, Peru, Philippines, Saudi Arabia,
St. Lucia, St. Vincent, Suriname, Taiwan, Trinidad,
United States (U.S.), Venezuela, Vietnam