Set Raid Level - easyRAID F8P U3TT User Manual

5. Set RAID Level

Move cursor (
None ), press " Enter " to confirm.
Warning
All data on the disk drives will be lost by changing the RAID
Level.
* RAID Level " None " = JBOD
6. Set Hot Spare Disk
Select " Yes " to set one Disk Drive as a Hot-spare Disk.
(Valid for RAID Level 5 and 3 , the total number of Disk Drives
installed must be more than 3 Disk Drives )
7. Set SCSI ID
Each device on a specific SCSI bus must be configured with a
target address ( which is a "SCSI ID" ) which is different from any
other devices on the SCSI Bus.
The default SCSI ID for the Disk Array is ID 0.
If you needed to assign a different ID # for your Disk Array. The
available SCSI ID# for this Disk Array are ID# 0 ~ 14 .
You must assign a different SCSI ID to each SCSI device
on the SCSI Bus. The SCSI ID# must be Unique for each
device.
) to the desired RAID Level ( 0, 1, 3, 5, 0+1,
3-5 5
Configuration