Switching Of Search Dial Mode - Sony HDW-F500 Maintenance Manual

1-11. Switching of Search Dial Mode

The search dial of this unit can be switched to the jog
mode or shuttle mode using the following two methods.
. By selecting the SHUTTLE/JOG button
When the SHUTTLE button is pressed, the shuttle mode
is set.
When the JOG button is pressed, the jog mode is set.
. By pushing the search dial
Each time the search dial is pushed, the mode switches
between the shuttle mode and jog mode.
This method can be validated or prohibited.
Validating the Push Method
1. Turn OFF the power switch and wait for 30 seconds.
2. Fix the lower control panel at 90d.
3. Loosen the screw on the back of the search dial shown
in the figure.
4. Slide the mode selection plate in the arrow direction
until it touches the end.
Lower control panel
<Rear View>
Mode selection plate
HDW-F500E MMP1
5. Check that the search dial shaft can be seen from the
Shaft of search dial
The shaft can be seen from the round hole
Prohibiting the Push Method
1. Turn OFF the power switch and wait for 30 seconds.
2. Fix the lower control panel at 90d.
3. Loosen the screw on the back of the search dial shown
4. Slide the mode selection plate in the arrow direction
5. Check that the search dial shaft can be seen from the
Search dial
B3 x 14
The shaft cannot be seen
round hole of the mode selection plate, tighten the
screw.
<Rear View>
in the figure.
until touches the end.
round hole of the mode selection plate, tighten the
screw.
<Rear View>
Round hole
from the round hole
1-11. Switching of Search Dial Mode
B3 x 14
Mode
selection
plate
Round hole
B3 x 14
Mode
selection
plate
1-49