Rail Brackets; Plate Nuts (Large) - Sony HDW-F500 Maintenance Manual

1-6. Installation of HDW-F500
<Attachment of rack angles (handles)>
(8) Remove the four screws (B4 x 6) shown in the figure
from both the left and right sides of the unit.
B4 x 6
B4 x 6
(9) Attach the two rack angles to the unit using the four
screws (PSW4 x 16) provided with the rack mount kit.
Tightening torque: 1.2 N . m {12.2 kgf . cm}.
PSW4 x 16
Rack angle
PSW4 x 16
n
Keep the screws (B4 x 6) removed properly.
Be sure to use these screws when removing the rack angles
and directly attaching the side panel using these screws.
Using the screws for attaching the rack angles (PSW 4 x
16) accidentally will cause problems in the operations of
the unit because they are longer than the (B4 x 6) screws.
1-16
<Temporary attachment of rail brackets>
(10)Slide the outer rail and intermediate rail as shown in
B4 x 6
B4 x 6
(11)Slide the ball retainer to the end as shown in the figure,
Rack angle
PSW4 x 16
the figure, and attach the rail bracket to the outer rail
temporarily using the plate nuts (large) and the two
screws.
Plate nut (Large)
Rail bracket
Outer rail
Intermediate rail
and attach the rail bracket to the outer rail temporarily
using the plate nuts (large) and two screws.
Plate nut
(Large) Rail bracket
B4 x 8
Outer rail
Intermediate
rail
Ball retainer
B4 x 8
HDW-F500E MMP1