Removing/Installing The Upper/Lower Control Panels - Sony HDW-F500 Maintenance Manual

2-5. Removing/Installing Cabinet
Upper Lid
1. Loosen the three screws with stopper.
2. Lift up the connector panel side of the upper lid, and
pull it out in the arrow direction.
To install, perform the reverse order of this procedure.
Side Panels (Same for left and right)
1. Remove the four screws (B3 x 6) and remove the
handle.
2. Remove the four screws (B3 x 6) and remove the side
panels.
To install, perform the reverse order of this procedure.
Bottom Plate
n
. With the handle attached, place the unit with its right
side panel facing down for removal and installation.
Hold the lower handle with your hand so that it does not
hang down.
1. Remove the six screws, and remove the bottom plate.
To install, perform the reverse order of this procedure.
2-4
2-5-2. Removing/Installing the Upper/Lower
Control Panels
n
Be sure to turn off the POWER switch and unplug the
power cord before starting the removal/installation.
Upper Control Panel
1. Remove the upper lid.
(Refer to "2-5-1. Removing/Installing the Upper Lid,
Side Panels, Bottom Plate".)
2. Remove each screw on the left and right.
3. Insert your fingers between the panel and chassis, and
pull out the edge of the panel to remove it.
BVTT3 x 6
Upper control panel
4. When installing, match the protrusions of the panel to
the holes on the chassis, and secure with the screws.
BVTT3 x 6
Protrusion
Upper control panel
Protrusion
BVTT3 x 6
Chassis
BVTT3 x 6
HDW-F500E MMP1