Switching Search Dial Mode - Sony MSW-A2000 Installation Manual

1-13. Switching Search Dial Mode

There are two kinds of operation to switch the search dial
on the lower control panel between jog mode and shuttle
mode.
. SHUTTLE/JOG button selecting
To enter the shuttle mode, press the SHUTTLE button.
To enter the jog mode, press the JOG button.
. Search dial pressing
When you press the dial, the search dial toggles between
shuttle and jog modes.
It is possible to prohibit a manner of toggling.
Prohibiting Search Dial Pressing
1. After pressing the release levers, open the lower
control panel as shown in the figure below.
2. Loosen a screw on the backside of the search dial as
shown in the figure.
n
If it is difficult to loosen the screw, remove the lower
control panel unit in advance.
(Refer to Section 1-12.)
3. Slide the mode selection plate in the direction indicat-
ed by the arrow until it contacts the portion A.
Release lever
Lower control panel unit
Back view
Mode selection plate
Screw
MSW-A2000
MSW-A2000P
4. Check to see that the shaft of the search dial is not seen
in the round hole of the mode selection plate, and then
tighten the screw.
Back view
Mode selection plate
Screw
Allowing Search Dial Pressing
1. Open the lower control panel. (Operation side up)
2. Loosen a screw on the backside of the search dial as
shown in the figure.
3. Fully slide the mode selection plate in the direction
indicated by the arrow.
4. Check to see that the shaft of the search dial is seen in
the round hole of the mode selection plate, and then
tighten the screw.
Back view
Release lever
Mode selection plate
Screw
Search dial
Portion A
1-13. Switching Search Dial Mode
The shaft is not seen.
Search dial shaft
The shaft is seen.
Round hole
Round hole
1-21