Sony HDW-F500 Maintenance Manual page 31

7. Insert the supplied two screws (PSW3 x 6) into the holes of the DPR-105 board, then tighten them
toward the propping shaft head respectively.
DIF-91A board
DPR-105 board
8. Install the shield plate with the removed six screws (PSW2.6 x 5).
n
On the upper two screws, hang the removed harness holders respectively before tightening them.
9. Insert the DIF-91A board into the specified slot of the HDW-F500.
10. Connect the eight coaxial connectors (A through H) to the specified positions which labeled "A
through H" stickers on the DIF-91A board as shown in the below figure.
After connecting the eight coaxial connectors, fix the coaxial cable G and H with cable clamps.
DIF-91A board
Cable clamp
11. Install the board retainer (L) plate, then install the upper lid to HDW-F500.
HDW-F500E MMP1
Coaxial cable
F
B
A
G
PSW3 x 6
Cable clamp
H
E
D
C
1-7. Installation of Optional Boards
1-21