Regulations Covering Pellet Stove Installation; Before Operating Your Stove - Drolet Edison Installation And Operation Manual

Edison Installation and Operation Manual

2.2 Regulations Covering Pellet Stove Installation

When installed and operated as described in these instructions, this pellet stove is suitable
for use as a freestanding heater in residential installations.
In Canada, the CSA B365 Installation Code for Solid Fuel Burning Appliances and
Equipment and the CSA C22.1 Canadian National Electrical Code are to be followed in the
absence of local code requirements. In the USA, the ANSI NFPA 211 Standard for
Chimneys, Fireplaces, Vents and Solid Fuel-Burning Appliances and the ANSI NFPA 70
National Electrical Code are to be followed in the absence of local code requirements.
This stove must be connected to a pellet vent system complying with the requirements for
Pellet Vent in the standards UL 103, UL 641, ULC S629M, CAN/ULC S609 and ULC/ORD
C441 or to a code-approved masonry chimney with a stainless steel flue liner.

2.3 Before Operating Your Stove

Some minor installation and adjustment are required prior to use:
• If your unit has the optional LCD touch screen sliding support, it can be installed on the
left at the back of the stove; (see Appendix B: LCD Touch Screen Supports).
• If you do not use the optional LCD touch screen sliding support, you can install the
LCD touch screen wall mount support provided in the owner's manual kit on the side or
at the back of the stove; (see Appendix B: LCD Touch Screen Supports).
• See that handle and door are well adjusted (see section 8.1.9: Door Adjustment).
• The stove must be leveled using threaded legs.
• Make sure to remove all tools or accessories (A-E) that have been inserted in the stove
for transportation purposes (see following illustration).
• Make sure the fresh air intake back draft shutter (F) works freely.
• Remove the insulating film (G) from the Main Board Battery (H).
• If your stove is equipped with the auxiliary battery system, connect it to the stove (see
Appendix C: Battery Holder kit (AC01452) and Optional 24V (2X 12V) battery kit
(AC01454))
NOTE: For first start-up, see Section 7: Stove operation.
11