Table of Contents
Advertisement
Edison Installation and Operation Manual
9.3.2 No Fuel
The stove ran out of pellets. Refill the hopper. Press "Reset" then "Feed and Start"
(see Section 6.1.11: Filling or Purging Auger Housing).
The burn pot holes are blocked. Remove the burn pot and clean it thoroughly.
The auger is jammed or auger motor failed. Go to the troubleshooting page on the
LCD touch screen (see Section 9.2: Testing Components) screen and test auger
motors. Make sure that the hopper lid is closed. If one of the motors is not running
check if motor is defective or if the auger is jammed.
HOPPER AUGER
A
Screws
B
Auger and motor assembly
C
gasket
57
Advertisement
Table of Contents
