Multi-Camera System - Sony DXC-C33P Instructions For Use Manual

Connecting Two or More Cameras — Multi-Camera System
Sync signal generator
Sync
(VBS or
BS) output
connector
VBS
OUT
VIDEO
IN
Video input
connector
Video monitor,
VCR, etc.
Notes
• Perform the following to synchronize the picture tone of the cameras when
switching between two or more cameras connected to a video switcher:
- Supply the same sync signal to the VD/SYNC connectors on the camera
control unit.
- Adjust the subcarrier and horizontal synchronization phases for all cameras.
For more details, see "Adjusting the Picture Tone in a Multi-Camera System"
on page 31.
• Turn on the power of the sync signal generator after all other equipment is
switched on
75-ohm coaxial cable
T VIDEO
OUTPUT
VIDEO
IN
Switcher, etc.
VBS OUT
75-ohm coaxial cable
T VIDEO OUTPUT
.
VD/SYNC
OUT PUT FS/TRIG IN EXT SYNC
VIDEO
DV HD
REMOTE
S-VIDEO RGB/SYNC VD/SYNC
Camera control unit
(rear)
VD/SYNC
OUT PUT FS/TRIG IN EXT SYNC
VIDEO DV HD
REMOTE
S-VIDEO RGB/SYNC VD/SYNC
Camera control unit
(rear)
Camera
head (rear)
CCMC-20P05/10/30
camera cable
CAMERA
(front)
A C I N
Power cord
Camera head (rear)
CCMC-20P05/10/30
camera cable
A C I N
CAMERA
(front)
Power cord
39
Connections