Playing Back Tapes; Playing Back A Tape - JVC UX-J60 Instructions Manual

Playing Back Tapes

You can play back type I tapes.

Playing Back a Tape

1
Press PUSH OPEN 0 on the unit.
2
Put a cassette in with the exposed part of
the tape down.
3
Press PUSH OPEN 0 again to close the
cassette holder.
4
Press TAPE 2 3.
The unit automatically turns on and the
tape starts playing. The tape direction
indicator (3 or 2) flashes slowly on the
display.
• Each time you press the button, the tape direction
changes:
3 : plays the front side.
2 : plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the Reverse Mode is set to
"To play both sides—Reverse Mode.")
If no cassette is inserted when you press TAPE 2 3
"NO TAPE" appears on the display.
17
To stop playing, press 7.
To fast-wind to the left or to the
right, press ¢ or 4 while the
tape is not running.
The tape direction indicator (3 or 2)
starts flashing rapidly on the display.
PUSH OPEN
To remove the cassette, press PUSH OPEN 0 on the unit.
• If the tape is playing, stop it first.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE (reverse mode).
• Each time you press the button, the Reverse
Mode changes as follows:
• DO NOT open the cassette holder when the tape
• The use of C-120 or thinner tape is not
TAPE
or . (See
: The deck automatically stops after playing both
sides of the tape. Stops when playback in the 2
direction is finished.
: The deck continues to play both sides of the tape
until 7 is pressed.
: The deck automatically stops after playing one
side of the tape.
is running.
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
REV.
MODE