Common Operations; Setting The Clock; Setting The Am Tuner Interval Spacing - JVC UX-J60 Instructions Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the unit's clock.
When you plug the AC power cord into the wall outlet,
"0:00" starts flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start over from step 1 .
• For UX-J60 only, you can also use CLOCK/TIMER on the
unit for this operation.
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press UP or DOWN to
adjust the hour, then
press CLOCK/TIMER.
The minute digits start flashing.
3
Press UP or DOWN to adjust the minute,
then press CLOCK/TIMER.
To check the clock time during play
On the remote control ONLY:
Press DISPLAY (grey-colored).
• Each time you press the button, the source
indication and the clock time alternate on the
display.
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to "0:00" right away. If this happens, set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
9
To change the clock
1 Make sure the
2 Press CLOCK/TIMER repeatedly until the unit enters
3 Repeat steps 2 and 3 of the procedure of "Setting the
CLOCK
/TIMER
4 Press and hold CLOCK/TIMER again so that the

Setting the AM Tuner Interval Spacing

UP
CLOCK
/TIMER
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
DOWN
When shipped, the built-in AM tuner is set to 9 kHz spacing.
You can change it to 9 kHz or 10 kHz spacing only while the
unit is on standby.
On the unit ONLY:
To select 10 kHz intervals, press
FM/AM while holding ¢.
To select 9 kHz intervals, press
FM/AM while holding 4.
The preset stations are erased. You will need to preset the stations
DISPLAY
again. (See page 12.)
(timer) indicator is not lit on the
display.
• If it is lit, press and hold CLOCK/TIMER until it goes
off.
the clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER, the unit enters the
timer setting mode. (See page 20.)
Clock."
(timer) indicator goes off.
When you change the setting