Terminal Block Diagram; Final Setup - Fetco CBS-2131XTS User Manual

Terminal Block Diagram

Electrical Configurations Terminal Block Diagram – North America & International
CBS-2131
120 volt models
Factory Configuration:
Attached cord 120 VAC, 3 wires
GROUND
LUG
GROUND WIRE
!MUST BE INSTALLED!

Final Setup

1. Turn on incoming water supply line and carefully inspect both inside and
outside of the brewer for leaks in all fittings and tubes
2. Turn on power.
3. Press the brewer's main power switch (located on the lower right of the
back of the equipment)
SCREENS SHOWN TO THE RIGHT WILL APPEAR
4. The water tank will begin filling. FETCO Home Screen #1 will read
"FILLING".
5. When the water level rises and is sensed by the probe at the top of the
tank the heaters will activate
6. Heaters are automatically disabled until the tank is full.
7. While the water is heating Screen #2 "HEATING" will display and the
actual water temperature will be displayed.
8. After the water has reached the set temperature Screen #3 will display
"READY"
9. Review the Operating Instructions. Brew one full batch (water only) on
each side to confirm proper fill levels. The brewer is factory set with water
only (no coffee) to dispense the correct amount of water. If the actual
volume is slightly different from the programmed volume, fine tuning the
brewer may be necessary. See Calibrate Valves in the OUTPUT section
in the PROGRAMMING section.
10. Re-attach the covers after one final inspection for leaks. Look closely in
the top of the brewer section at the dispense fittings during this
inspection.
L1 N L2
L2 - NOT USED
For 120 volt
CORD WITH
NEMA 5-15P or 5-20P
or without PLUG
Final Setup
(some)CBS-2131 and (all)CBS-2132
208-240 volt models
Factory Configuration:
Terminal block for professional installation
GROUND LUG
GRO UND WIRE
!MUST BE INSTALLED!
NEW FETCO CONFIGURATIION METHOD!
FETCO Home Screen #1 "FILLING"
FETCO Home Screen #2 "HEATING"
FETCO Home Screen #3 "READY
23
L1 N L2
120V 120V
N
NOT USED
208-240V