Controlling Ts-590G From A Pc Using The Usb Connector - Kenwood TS-590SG Manual

08 EXPANSIVE APPLICATION SOFTWARE

8.2.2 Controlling TS-590G from a PC using the USB Connector

The microphone connected to the TS-590SG and the transceiver s built-in speaker are used.
Control Virtual COM port driver
signal and ARCP-590G
Audio signal
8.2.3 Controlling TS-590SG from a PC using the COM and ACC2 connectors
(microphone and speaker connected to the PC to be used)
The microphone and speaker connected to the PC are used. The ACC2 connector is used to input or output the audio
signal of TS-590SG.
Control
ARCP-590G
signal
Audio signal
Caution:
◆ To use the ACC2 connector for input/output of the audio signal, ARUA-10 is not required.
8.2.4 Controlling TS-590SG from a PC using the USB connector (microphone and
speaker connected to the PC to be used)
The microphone and speaker connected to the PC are used. The USB connector is used to input or output the audio
signal of TS-590SG.
Virtual COM
Control
port driver and
signal
ARCP-590G
Windows standard
Audio signal
driver and ARUA-10
56
PC
Software
-
PC
Software Hardware
The microphone
- and speaker
connected to a PC
PC
Software Hardware
The microphone
and speaker
connected to a PC
Type of Connection
Hardware
- USB cable
- No connection
Type of Connection
- RS-232C cable
Home-made audio
cable
Type of Connection
-
USB cable
TS-590SG
Hardware
* Connected to the USB
connector
The microphone connected
to the TS-590SG and
the transceiver s built-in
speaker
TS-590SG
Hardware
* Connected to the COM
connector
* Connected to the ACC2
connector
TS-590SG
Hardware
* Connected to the USB
connector