Expansive Application Software; Windows Related Software; System Configurations; Controlling Ts-590S From A Pc Using The Com Connector - Kenwood 50 MHZ ALL MODE TRANSCEIVER TS-590S User Manual

8 EXPANSIVE APPLICATION SOFTWARE

8.1 Windows Related Software

This chapter describes the Windows related software to be used to control the TS-590S from a PC.
Following are the Windows related software products that can be used with the TS-590S.
Name
ARCP-590 This software enables control of the TS-590S from a PC.
This host program is used on the host station PC when the TS-590S is remotely controlled over
ARHP-590
a network. The software is used in combination with ARCP-590.
This VoIP software is to transfer the TX and RX audio signals when remotely controlling the
TS-590S over a network.
ARVP-10
Note: The software is composed of ARVP-10H and ARVP-10R.
This software enables use of the microphone and speaker of a PC in place of those on the
TS-590S. It enables the audio signal from the PC's microphone to be transfered via USB audio
and transmitted from the TS-590S. Also, the audio output of the TS-590S can be emitted from
the PC's speaker via USB audio.
ARUA-10
Note:
 If you are using a home-made audio cable connected to the ACC2 connector, this software is not
required.
 This software is not required if this is used over a network.
Being installed on the PC, this supports use of ARCP-590 and ARHP-590 after the TS-590S is
Virtual COM Port
connected to a PC with a USB cable.
Driver
Note: If the TS-590S is connected to the PC with a serial cable, this software is not required.

8.2 System Configurations

We will provide some typical system configurations using the TS-590S and Windows software.

8.2.1 Controlling TS-590S from a PC using the COM Connector

The microphone connected to the TS-590S and the transceiver's built-in speaker are used.
Software
Control signal ARCP-590
Audio signal
52
CONTENTS
Table 8-1 Windows Related Software for TS-590S
PC
Hardware
-
- -
Description
Type of
Connection
RS-232C cable * Connected to the COM connector
The microphone connected to the
No connection TS-590S and the transceiver's built-in
speaker
TS-590S
Hardware
TS-590S