Denon AVR-S510BT Owner's Manual page 85

Contents Connections
Levels
Set the volume of the test tone to be the same at the listening position
when it is output from each speaker.
o Test Tone Start
A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0 The set "Levels" are reflected in all sound modes.
0 When headphones are connected to the PHONES connector on this unit, you
cannot set "Levels".
o Set Defaults
The "Levels" settings are returned to the default settings.
Front panel Display
Playback Settings
Crossovers
Set in accordance with the lower limit frequency of the base frequencies
that can be played back through each speaker.
o Set the crossover frequency
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz /
120 Hz / 150 Hz / 200 Hz / 250 Hz
(Default : 80 Hz)
0 "Crossovers" can be set when the "Subwoofer Mode" setting is "LFE+Main", or
when you have a speaker that is set to "Small". (v p. 86)
0 The default crossover frequency is "80 Hz", which will work best with the
widest variety of speakers. We recommend setting to a higher frequency that
the crossover frequency when small speakers are used. For example, set to
"250 Hz" when the frequency range of the speakers is 250 Hz – 20 kHz.
0 Sounds below crossover frequency is cut off in the output from the speaker set
up in "Small". The cut off bass frequencies is output from the sub-woofer or
front speaker.
85
Rear panel
Tips
Remote Index
Appendix