Dell PowerEdge R220 Owner's Manual page 90

Error Code Message Information
SEC0033
Message
Details
Action
SEL0006
Message
Details
Action
SEL0008
Message
Details
Action
SEL0012
Message
Details
Action
SEL1204
Message
Details
Action
TMP0118
Message
Details
Action
90
The chassis is open while the power is off.
The chassis was opened while the power was off. System
security may have been compromised.
Close the chassis and verify hardware inventory. Check
system logs.
All event logging is disabled.
This message is displayed when all event logging has been
disabled by the user.
If unintended, re-enable logging.
Log is full.
When the event log is full, additional events are not written
to the log. Older events may be overwritten and lost. This
message may also appear if the user disabled event logging.
Backup and clear log.
Could not create or initialize the system event log.
If the system event log fails to initialize, platform status and
failure events are not captured. Some management software
do not report platform exceptions.
Reboot the management controller or iDRAC. Cycle system
input power. If problem persists call support.
An unknown system hardware failure detected.
If the system event log failed to initialize, platform status and
failure events are not captured. Some management software
do not report platform exceptions.
Re-configure system to the minimum supported
configuration. If issues persists, contact support.
The system inlet temperature is less than the lower warning
threshold.
Ambient air temperature is too cool.
Check the system operating environment.