Changing Your Wireless Network Name(Ssid) And Wireless Security Key/Password - Zoom 5360 User Manual

You can check to see if all other clients that you plan to put on the network support WPA
or WPA2. You can do this by checking the manual that came with each device or by
checking the configuration software for the installed device. Look under Security or
Encryption or Setup or Advanced Features. Most devices will support one of these
modes.
•
To change the Wireless Network Name (SSID) or Wireless Security
Key/Password (Pre-Shared key) used by your Cable Modem/Router go to
Changing your Wireless Network Name(SSID) and Pre-Shared
•
If any of the devices you want to connect to your wireless network do not support
WPA or WPA2, go to
•
If you need to set up an unsecured network, see
Changing your Wireless Network Name(SSID) and Wireless
Security Key/Password
Most likely your previous wireless network used 2.4GHz. If you want to change your
Cable Modem/Router settings to match your existing network settings follow the steps
below. If you have devices that support 5GHz then you should connect to the Cable
Modem/Router's 5G network. For instructions on connecting to the 5G network refer to
Chapter 3, Connecting other Devices to the Cable
To check if your device supports the 5 GHz, you can scan for available wireless networks
on your device. If you see a wireless network named Zoomxxxx-5G than your devices
supports 5 GHz and you should follow the instructions for connecting that device to the
Cable Modem/Router found in Chapter 3. If you only see Zoomxxxx then your device
does not support 5 GHz. In both cases, xxxx are the last 4 digits of the CM MAC address.
You can find Zoomxxxx printed on the label of your Cable Modem/Router. When the
cable modem is standing vertically this label is located on the side of your modem.
1 Open the Zoom Configuration Manager by typing the following in your Web browser's
address bar: http://192.168.0.1
2 In the Login dialog box, type the User Name and Password in lower case, then click
Login. (Here we assume the default User Name and Password.)
User Name: admin
Password: admin
Setting Up Security Using
29
Key.
WEP.
Disabling Security
Modem/Router.
.