Related Manuals for OZ Charge OC-PRO600
Summary of Contents for OZ Charge OC-PRO600
- Page 1 Model: OC1206U / OC1212U Models: OC-PRO600 / OC-PRO1200 OWNER’S MANUAL OWNER’S MANUAL AUSTRALIAN & NEW ZEALAND STANDARD AS/NZS 60335.2.29 APPROVED AUSTRALIAN & NEW ZEALAND STANDARD AS/NZS 60335.2.29 APPROVED...
-
Page 2: Important Safety Advice And Warnings
Congratulations on purchasing an Oz Charge fully automatic switched mode 12 Volt battery charger, maintainer and rejuvenator. Please take the time to carefully read and understand this manual before using this product. IMPORTANT SAFETY ADVICE AND WARNINGS • The charger is designed to charge and maintain 12V conventional lead-acid batteries only. - Page 3 Silent Charge Mode: Charges at a slightly reduced charge rate so the cooling fan is not required. • Maintenance Mode: Ideal and recommended for long term maintenance charging or for charging Note: Image shows OC-PRO600 model. smaller batteries. 2 • Oz Charge manual www.ozcharge.com.au...
-
Page 4: Temperature & Safety Protection
• ECO MODE: This Oz Charge battery charger has a built in ultra low power consumption circuit. If AC power is connected and the battery is disconnected, after 10 seconds the charger will automatically go into an ECO mode. During this mode the power drawn is less than 0.36W which totals 0.01kWh per day power consumption. -
Page 5: Electrical Parts & Accessories
Battery Type and Charge Rate settings you will use. • Ensure the battery is in a well ventilated area and the charger should be as far away from the battery as the cables permit. 4 • Oz Charge manual www.ozcharge.com.au... - Page 6 / or reduce your battery life. Note: If the Fault Indicator LED illuminates Red, please check your connections as it’s likely that the Positive and Negative Leads are reversed. 5 • Oz Charge manual www.ozcharge.com.au...
-
Page 7: The Charging Process
The battery analysis stage checks the condition of the battery after the charge cycle is completed. If the battery voltage drops too quickly during the analysis mode, this means the battery is probably faulty. If the battery analysis failed, this is indicated by the Green Full LED flashing. 6 • Oz Charge manual www.ozcharge.com.au... - Page 8 Note: Check electrolyte levels if possible after charging as they may need topping up with distilled water. (This does not apply to sealed maintenance free batteries) LED STATUS INDICATOR TABLE: Note: Image shows OC-PRO600 model. Status Description Battery Type LED’s...
- Page 9 8 • Oz Charge manual www.ozcharge.com.au...
-
Page 10: Troubleshooting
REPLACEMENT PARTS For the full range of replacement parts and accessories, please visit our website: www.ozcharge.com.au. / www.ozcharge.co.nz 9 • Oz Charge manual www.ozcharge.com.au... -
Page 11: Year Product Warranty
Outside of Australia: +61 3 9482 2203 Website: www.ozcharge.com.au / www.ozcharge.co.nz If the Authorised Supplier and / or Oz Charge service centre concludes that while under normal use, a product failure or malfunction occurred during the warranty period and was caused by a defect in material or workmanship (see Exclusions), the Customer will be asked to ship to the nearest service point for repair or replacement, at our discretion. - Page 12 3) Check connection of ring terminals and 2 pin connectors. Note: For use on 12 Volt battery only. *OC-PRO1200 has an additional patch harness. SAA Approval No. GMA-102826-EA-002 / GMA-102826-EA-003 OC-PRO600 / OC-PRO1200 Owner’s Manual: Rev 1.0 - 03/15 - Specifications subject to change without notice.
Need help?
Do you have a question about the OC-PRO600 and is the answer not in the manual?
Questions and answers