Placing A Phone Call; Phone Or Extension Numbers - Grandstream Networks HT701 User Manual

Analog telephone adaptor
Hide thumbs Also See for HT701:
Table of Contents

Advertisement

16
Firmware Version
17
Firmware Upgrade
47
"Direct IP Calling"
86
Voice Mail
99
"RESET"
"Invalid Entry"
"Device not registered"
Five Success Tips when using the Voice Prompt
1. "*" shifts down to the next menu option
2. "#" returns to the main menu
3. "9" functions as the ENTER key in many cases to confirm or toggle an option
4. All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168000026. No decimal is needed).
5. Key entry cannot be deleted but the phone may prompt error once it is detected

PLACING A PHONE CALL

PHONE OR EXTENSION NUMBERS

1. Dial the number directly and wait for 4 seconds (Default "No Key Entry Timeout"); or
2. Dial the number directly and press # (Use # as dial key" must be configured in web configuration).
FIRMWARE VERSION 1.0.7.3
Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the following
three options:
- always check
- check when pre/suffix changes
- never upgrade
Enter the target IP address to make a direct IP call, after dial tone.
(See "Make a Direct IP Call".)
Number of Voice Mails
Press "9" to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook If the device is
not register and the option "Outgoing Call without Registration" is in
NO
HT70X USER MANUAL
Page 18 of 52

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ht704Ht702

Table of Contents