Toyota CAMRY 2016 Owner's Manual page 362

360
6-4. Other interior features
Programming a Rolling Code system (for U.S. owners)
■
If your device is Rolling Code equipped, follow the steps under the heading
"Programming HomeLink
Locate the learn button on the ceiling mounted garage door
1
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
motor for the location of the learn button.
Press the learn button.
2
Following this step, you have 30 seconds in which to initiate step 3
below.
Press and hold the vehicle's programmed HomeLink
3
2 seconds and then release it. Repeat this step once again. The
garage door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
Repeat the steps above to program another rolling code system
4
for any of the remaining HomeLink
Programming an entry gate (for U.S. owners)/Programming a
■
device in the Canadian market
Place the remote control transmitter 1 to 3 in. (25 to 75 mm)
1
away from the HomeLink
Keep the HomeLink
Press and hold the selected HomeLink
2
Repeatedly press and release (cycle) the remote control trans-
3
mitter for 2 seconds each until step 4 is completed.
When the HomeLink
4
release the buttons.
Test the HomeLink
5
grammed button. Check to see if the gate/device operates cor-
rectly.
Repeat the steps above to program another device for any of the
6
remaining HomeLink

" before proceeding with the steps listed below.

signal and operate the garage door.

buttons.

indicator light in view while programming.

indicator light starts to flash rapidly,

operation by pressing the newly pro-

buttons.
I n f o r ma t i o n P r o v i d e d b y :

buttons.

button.

button for