Citizen CT-S280 Command Reference Manual page 199

CT-S281
• Setting MSW 4 (a=4)
n b (Set Value)
At the selection of Black mark/Label paper, enables auto
48 (Default)
end-measurement.
1
At the selection of Black mark/Label paper, disables auto
49
end-measurement.
48 (Default) Finding top of form at power ON disabled.
2
49 Finding top of form at power ON enabled.
48 (Default) Feed & Cut at TOF disabled.
3
49 Feed & Cut at TOF enabled.
48 (Default) Uses thermal roll paper.
4
49 Uses Black mark paper/ label paper.
48 (Default) Detects paper position and black mark.
5
49 Detects paper position and inter-label distance.
48 (Default) Paper type selection disabled
6
49 Paper type selection enabled
Label mode 1 - Auto paper type selection disabled
48 (Default)
7
49 Label mode 2 – Auto paper type selection enabled
48 Cut method is determined according to the cut command.
8
Partial cut is performed regardless of cut command. (full
49 (Default)
but by command: enabled).
*** Default setting of MSW4-4 depends on the model. Thermal paper is the
default of the standard model.
*** MSW 4-5 is valid only when black mark/label is set. If MSW4-4 is set for
thermal paper, it is invalid
*** MSW4-8 is invalid when black mark/label is selected. Cut type for black
mark/label paper is only full cut.
Function
- 198 -
• Setting MSW 5 (a=5)
n b (Set Value)
1 49 (Default) Reserved
2 48 (Default) Reserved
48 USB mode virtual serial.
3
49 (Default) USB mode printer class.
4 48 (Default) Reserved
5 48 (Default) Reserved
6 48 (Default) Reserved
48 (Default) If PNE is released, Error LED is automatically turned off.
7
49 Error LED is not turned off until the paper is exchanged
(printer Cover is opened) even if PNE is released.
8 48 (Default) Reserved
Function