Installation; Positioning And Levelling; Electrical Connections - Hotpoint Ariston C3V M57 Operating Instructions Manual

Installation

! Before operating your new appliance please read
this instruction booklet carefully. It contains
GB
important information concerning the safe installation
and operation of the appliance.
! Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
! The appliance must be installed by a qualified
professional according to the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the appliance has been
disconnected from the electricity supply.
We recommend cleaning the oven before
using it for the first time, following the
instructions provided in the "Care and
maintenance" section.

Positioning and levelling

cupboards whose height does not exceed that of the
! It is possible to install the appliance alongside
hob surface.
! Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heat-
resistant material (T 90°C).
• Place it in the kitchen, the dining room or the bed-
To install the appliance correctly:
sit (not in the bathroom).
• If the top of the hob is higher than the
the appliance must be installed at least 200 mm
away from them.
HOOD
600
Min. mm.
• Do not position blinds behind the cooker or less
than 200 mm away from its sides.
instructions listed in the relevant operating manual.
• Any hoods must be installed according to the
Levelling
2
cupboards,
installed underneath a wall
• If the cooker is
cabinet, there must be a
mm between this cabinet
minimum distance of 420
This distance should be
and the top of the hob.
increased to 700 mm if
the wall cabinets are
flammable ( see figure ).
If it is necessary to level the
appliance, screw the
adjustable feet* into the
places provided on each
corner of the base of the
cooker ( see figure ).
The legs* provided with the
appliance fit into the slots on
the underside of the base of
the cooker.

Electrical connections

Fitting the power supply cable
The cable should be suited to the type of electrical
connection used, according to the following
connection diagram:
400 3N
H05RR-F 5x2.5 CEI-UNEL 35363
H05VV-F 5x2.5 CEI-UNEL 35746
400V 2N
H05RR-F 4x4 CEI-UNEL 35363
H05VV-F 4x4 CEI-UNEL 35746
230V
H05RR-F 3x4 CEI-UNEL 35363
H05VV-F 3x4 CEI-UNEL 35746
To install the power supply cable correctly:
V
3
2
1
B
A
N
lower area of the terminal board.
6 6 6 6 6
3. Position wires N and
( see figure ) and perform the connection by
tightening the terminal board screws as much as
possible.
4. Position the remaining wires on terminals 1-2-3
and tighten the screws.
1 2 3 4
5
T N
R S
1 2 3 4 5
R
S
N
3 4 5
1 2
N
R
1. Loosen the screw V
in the terminal board
and pull the cover to
open it ( see figure ).
2. Position the connection
support A ( see figure )
according to the
connection diagram shown
above. The terminal board
is designed for single-
phase 230 V connection:
terminals 1, 2 and 3 are
connected to each other;
jumper 4-5 is located in the
according to the diagram