Section 1 - Installation; Mount The 1812 Classic - DKS 1812 Classic Installation & Owner's Manual

Installation of the 1812 Classic Telephone Entry System involves the installation of the hardware, by-pass board, and the wiring
of these components. Be sure that all dirt, metal or wood debris is removed from inside after mounting it. Any debris inside
could damage the control board and cause the 1812 Classic system to malfunction during operation.
When the 1812 Classic is used to control a vehicular gate with an automatic gate operator, it must be
mounted a minimum of ten (10) feet away from the gate and gate operator, or in such a way that a person
cannot operate the 1812 Classic system and/or touch the gate or gate operator at the same time.
WARNING

1.1 Mount the 1812 Classic

Use the specification dimensions on pages 2 and 3 to help with the installation of your chosen 1812 Classic model.
8

SECTION 1 - INSTALLATION

1
2
3
4
5
6
7
8
9
1 0
1 1
1 2
1 3
1 4
1 5
1 6
1 7
1 8
Remove the Control Board
The control board removal is the same for all models.
CAUTION The control board contains static sensitive
components. Discharge any static electricity from
your hands by touching a proper ground device
before removing the control board.
1. Unlock and open the 1812 door.
2. Disconnect the keypad plug and
door accessories plug from the
control board.
3. Remove the 4 screws.
Carefully remove control board.
Keep the control board in a protected
area during the mounting installation.
1812-065-V-12-14