JVC GY-HM600U Instructions Manual page 66

1 Select [Main Menu] B [TC/UB] B [TC
Preset] and press the Set button (R).
(A P102 [ TC Preset ] )
The [TC Preset] screen appears.
.
Memo :
When [TC/UB] B [TC Generator] is set to
0
"Regen", the parameter is displayed as "Regen"
and cannot be selected.
(A P102 [ TC Generator ] )
2 Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
During drop frame
.
Memo :
Press the [OIS/2] button to reset each digit to "0".
0
The cursor moves to the time digit (left).
3 Check the values and press the Set button
(R).
The time code is set and the screen returns
0
to [TC/UB].
To cancel the setting, press the [CANCEL]
0
button.
4 Press the [MENU] button.
Returns to the normal screen.
66
1
.
Memo :
Setting Time Code
1 Set [TC/UB] B [TC Generator] to settings
Cursor
2 Hold down the [MENU] button and press the
During non-drop
frame
.
3 Set the time code (hour, minute, second,
Memo :
Setting Time Code without Opening the
Menu
MENU/THUMB
AE LEVEL
CANCEL
Settings cannot be made in the following cases.
0
[TC/UB] B [TC Generator] has been set to
0
"Regen".
Menu screen is displayed.
0
The camera recorder is not in the Camera
0
mode.
other than "Regen".
(A P102 [ TC Generator ] )
[FOCUS ASSIST/1] button.
The [TC Preset] setting screen appears.
During drop frame
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
Press the [OIS/2] button to reset each digit to "0".
0
The cursor moves to the time digit (left).
MENU/THUMB
CANCEL
FOCUS ASSIST/1 OIS / 2
TIME CODE
Cursor
During non-drop frame