Technicolor MediaAccess TG650s Setup And User Manual page 103

Creating your own security level
Proceed as follows:
1 In the Toolbox menu click Firewall.
2 In the Firewall section, go to the Configure page.
3 In the Pick a task list, click Create a new Security Level.
4 In the Name box, type a name for the new security level and select an existing security level to clone from.
5 Click Apply.
Once you create a security level, you can not delete it anymore. It will always available in the list of available security
levels.
6 A page with the firewall settings of your newly created security level appears. Click Edit.
7 Enter the following information:
 The Name of the firewall rule.
The Source Interface and IP Address (range).

Use Any as IP address in case all traffic for the interface should be parsed.
Or you can type a User-defined IP address (range).
 The Destination Interface and IP Address (range)
Use Any as IP address in case all traffic for the interface should be parsed.
Or you can type a User-defined IP address (range).
The Service type of the traffic; this can be a protocol (DNS, SMTP,...) or a specific MediaAccess Gateway system

service.
8 Select an Action that should be done on traffic for which the firewall rules applies:
 Accept: to allow the traffic to pass
Deny: to drop the traffic (without notification)

 Count: to let the traffic pass, but count it (Hits)
9 Click Apply.
DMS-CTC-20111123-0002 v1.0
8 INTERNET SECURITY
97