Electrical Connection; Final Checks - Rangemaster Professional+ FXP 90 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.

Electrical Connection

This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical Engineers
(I.E.E.) regulations, and also the local electricity supply
company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED.
n n
Current Operated Earth Leakage Breakers
The combined use of your cooker and other domestic
appliances may cause nuisance tripping, so we
recommend that the cooker is protected on an individual
RCD (Residual Current Device) or RCBO (Residual Current
Breaker with Overload).
IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIED
ELECTRICIAN.
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double-pole
switch, having a contact separation of at least 3 mm in all poles.
The total electrical load of the appliance is approximately
3.6 kW. The cable size used should be suitable for this load
and comply with all local requirements.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (Fig. 7.13 and Fig. 7.14). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
These appliances are of type X with regard to protection
against overheating of the surrounding surfaces.

Final Checks

Hotplate Check
Check each burner in turn. There is a flame supervision device
(FSD) that stops the flow of gas to the burner if the flame
goes out.
To light a burner, push in and turn the associated control
knob to the high position indicated by the large flame symbol
().
The igniter should spark and light the gas. Keep holding the
knob pressed in to let the gas through to the burner for a few
seconds.
If, when you let go of the control knob, the burner goes out,
then the FSD has not been bypassed. Turn the control knob
to the Off position and wait for one minute before you try
again, this time making sure to hold in the control knob for
slightly longer.
Oven Check
Turn on the oven and check that it starts to heat up. Check
that the oven lights are working. Turn off the oven.
Note: The oven light bulb is not included in the guarantee.
INSTALLATION
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
L
N
ArtNo.130-0002 - Electrical connections single-phase
6mm² max
230 Vac 50 Hz
L1
N
L3
L2
6 mm² max
ArtNo.130-0003 - Electrical connections 3-phase
3N ac
230/400 V 50 Hz
27
N
L
L1 L2 L3 N
Fig. 7.12
Fig. 7.13
Fig. 7.14