Advertisement
If your receiver does not support 5 V antenna power, then please follow the next steps:
B. To power the antenna with external power adaptor:
1. Switch OFF your receiver and disconnect it from the 230 V mains power.
2. Take the short Coaxial (IEC male to IEC female) Cable. Connect the IEC Male end to your Set Top Box.
Normally the input connector on your receiver is marked as "ANT" (in) or as "RF" (in). Refer to the
User Manual of your Digital Terrestrial Receiver.
3. Connect the other end of the cable to the connector on the power injector that is marked as "Receiver".
4. Take the supplied "long" coaxial cable and connect the end with the "F connector" (screw type
connector) to the antenna. Carefully press the inner lead of the cable into the Female-F connector at
the back of the antenna. Turn the covering nut clockwise with your HANDS until it is fixed.
5. Connect the other side of the cable to the connector at the power injector, it is marked as "Antenna".
6. Insert the adapter to the 230 V mains power and insert the connector at the end of the lead to the
power injector - it is marked as "DC 9 - 12 V".
7. Proceed to chapter 5. "Installation of the antenna".
For point B - please see drawing below:
AC Adaptor (DC 9 V)
STB or Digital TV
8
Powering by Adaptor
Indoor
Coaxial Cable
Power Insert
Coaxial Cable
PART 1
Engli
sh
l
Outdoor
Water-Drop Loop
(recommended)
Advertisement
