Hoisting; Jump-Starting Procedures; Preparations For Jump-Start - Dodge 2010 Ram Truck Owner's Manual

Hide thumbs Also See for 2010 Ram Truck:

Table of Contents

496 WHAT TO DO IN EMERGENCIES

HOISTING

A conventional floor jack may be used at the jacking

locations. Refer to the graphics that show jacking loca-

tions. However, a floor jack or frame hoist must never be

used on any other parts or the underbody.

Never use a floor jack directly under the differential

housing of a loaded truck or damage to your vehicle

If your vehicle has a discharged battery it can be jump-

started using a set of jumper cables and a battery in

another vehicle or by using a portable battery booster

pack. Jump-starting can be dangerous if done improperly

so please follow the procedures in this section carefully.

NOTE: When using a portable battery booster pack

follow the manufacturer's operating instructions and

precautions.

Do not use a portable battery booster pack or any

other booster source with a system voltage greater

than 12 Volts or damage to the battery, starter motor,

alternator or electrical system may occur.

Do not attempt jump-starting if the battery is frozen.

It could rupture or explode and cause personal injury.

The battery in your vehicle is located in the front of the

engine compartment, behind the left headlight assembly.

I n f o r m a t i o n P r o v i d e d b y :

Table of Contents