Schwinn 830/Journey 8.0 Assembly Manual / Owner's Manual page 48

Condition/Problem Thingsto Check Solution
Console shuts off (enters Check electrical (wall) Make sure unit is plugged into a functioning wall outlet. Test the
sleep mode) while in use outlet outlet with a known functioning device such as a lamp.
Check connection at front Connection should be secure and undamaged. Replace adapter
of unit or connection at unit if either are damaged.
Check data cable integrity All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Check data cable Be sure cable is connected securely and oriented properly. Small
connections/orientation latch on connector should line up and snap into place.
Reset machine Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
If the above steps do not resolve the problem, contact Customer
Care for further assistance.
Fan will not turn on or will Reset machine Unplug unit from electrical outlet for 5 minutes. Reconnect to
not turn off outlet.
Fan will not turn on, but Check for blockage of fan Unplug unit from electrical outlet for 5 minutes. Remove material
Console operates from fan. If necessary, detach the Console to help with removal.
Replace the Console if unable to remove blockage.
Unit rocks/does not sit Check leveler adjustment Adjust levelers until machine is level.
level
Check surface under unit Adjustment may not be able to compensate for extremely uneven
surfaces. Move machine to level area.
Thumping sound when belt Walking belt Walking belt needs to be used for wear in period. Sound will go
operates away after the wear in period.
Walking belt not aligned Machine leveling Make sure the machine is level. Refer to the procedure for level-
ing the machine in this manual.
Walking belt tension and Make sure the walking belt is centered and tension is correct.
alignment Refer to the procedures for adjusting tension and aligning the belt
in this manual.
Motor sounds strained Silicone lubrication on Apply silicone to the inner surface of the walking belt. Refer to
walking belt the belt lubrication procedure in this manual.
Hesitation or walking belt Belt tension Adjust the belt tension at the rear of the machine. Refer to the
slips when in use orocedure for adjusting belt tension in this manual.
Belt stops moving while in Safety key Plug Safety Key into Console. (See Emergency Stop Procedure
use in the Important Safety Instructions section.)
Motor overload Unit may be overloaded and draw too much current, which
causes power to turn off to protect motor. Refer to maintenance
schedule for belt lubrication. Make sure the walking belt tension
_scorrect, and start unit again.
If the above steps do not resolve the problem, contact Customer
Care for further assistance.