Section
r:D (
Operating this unit
5
Press EQ to proceed to the 16-point ad-
justment.
The 16-point touch panel adjustment screen
appears,
• To cancel the adjustment. press and hold
VOLUME/MUTE,
6
Gently touch the center of the + mark
displayed on the screen with the touch
panel adjustment pen.
After you touch all the marks, the adj usted po-
sition data is saved,
•
Do not turn off the engine whi Ie saving the ad-
justed position data,
7
Press and hold VOLUME/MUTE to com-
plete the adjustment.
Using the AUX source
A separately sold auxiliary device such as VCR
or portable device can be connected to this
unit. When connected, auxiliary device is auto-
matically recognized as AUX source and as-
signed to AUX.
About AUX connection method
You have two methods to connect auxiliary de-
vice to this unit.
Mini pin plug cable (AUX 1)
When connecting auxiliary device using a mini
plug cable
iPod and portable audio/video player can be
connected to this unit via mini plug cable,
•
If an iPod with video capabilities is con-
nected to this unit via 3,5 mm plug (4 pole)
cable (e,g" CD-V150M), you can enjoy the
video contents of the iPod,
•
It is possible to connect a portable audio/
video player by using a 3,5 mm plug (4
pole) to RCA cable, which is sold sepa-
rately, However, depending on the cable, re-
verse connection between Red (right side
audio) cable and yellow (video) cable is re-
quired, Otherwise, audio and video may not
be correctly reproduced,
@
En
)
•
Insert the mini plug into the AUX input
jack on this unit.
For more details, refer to What's What on page
15,
IP-BUS-RCA interconnector (AUX 2)
When connecting auxiliary device using an IP
BUS-RCA Interconnector (sold separately)
•
Use an IP-BUS-RCA Interconnector such
as the CD-RB20/CD-RB10 (sold separetely)
to connect this unit to auxiliary device fea-
turing RCA output.
For more detai Is, refer to the IP-BUS-RCA Inter-
connector owner's manual,
• You can only make this type of connection if
the auxi Iiary device has RCA outputs,
Selecting AUX as the source
•
Touch the source icon and then touch
AUX 1/AUX 2 to select AUX as the source.
•
If the auxiliary setting is not turned on, AUX
cannot be selected, For more details, see Switch-
ing the auxiliary setting on page 41 ,
Setting the AUX title
The title displayed for the AUX source can be
changed,
•
Each title can be up to 10 characters long,
1
After you have selected AUX as the
source, touch AV MENU and
FUNGION MENU and then touch
NAME EDIT.
•
When the touch panel keys are not displayed,
you can display them by touching the screen,
2
Touch ABC to select the desired charac-
ter type.
Touch ABC repeatedly to switch between the
following character types:
Alphabet (upper case)-Alphabet (lower case)
-European letters, such as those with ac-
cents (e,g" ii,
ii,
a,
~)
• You can select to input numbers and symbols
by touching 123,