In this chapter you will ﬁnd information regarding safety which it is essential to
take note of when working with your device.
This device complies with the relevant safety regulations for data processing equipment,
including electronic ofﬁce machines for use in an ofﬁce environment. If you have any
questions, contact your sales outlet or our Help Desk.
The display surface of the device is sensitive to pressure and scratches. You should therefore
be careful with the display surface in order to avoid lasting damage (scratches).
If the device is brought into the installation site from a cold environment, condensation
can form. Before operating the device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
When installing and operating the device, please observe the notes on environmental
conditions in Chapter
"Setting up an ergonomic video workstation", Page
To ensure sufﬁcient ventilation, the air inlet and outlet openings of the device must be kept clear.
The device automatically sets itself to the correct voltage within the range from 100 V to 240 V.
Make sure that the local mains voltage is neither higher nor lower than this range.
Ensure that the power socket on the device and the mains outlet are freely accessible.
The ON/OFF switch does not fully disconnect the TV from the mains voltage. To disconnect
fully from the mains supply, remove the power plug from the socket.
The device is equipped with a power cable that complies with safety standards.
Use the supplied power cable only.
Lay the cables in such a way that they do not create a hazard (danger of tripping)
and cannot be damaged. When connecting the device, observe the relevant
notes in chapter
No data transfer cables should be connected or disconnected during a thunderstorm.
Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get
inside the device (danger of electric shock, short circuit).
The device is not waterproof! Never immerse the device in water and protect
it from spray water (rain, sea water).
In emergencies (e.g. damaged casing, elements or cables, penetration of
liquids or foreign matter), switch off the device, disconnect the power plug and
contact your sales outlet or our Help Desk.
Repairs to the device must only be performed by qualiﬁed technicians. Unauthorised opening
and incorrect repair may greatly endanger the user (electric shock, ﬁre risk).
Only use the screen resolution settings and refresh rates speciﬁed in Chapter
"Technical data", Page
any doubt, contact your sales outlet or our Help Desk.
A26361-K1240-Z120-7619, edition 1
"Technical data", Page 31
"Connecting the device", Page
31. Otherwise you may damage the device. If you are in
as well as the instructions in Chapter