Advertisement
R
epair
< 3 > Assembling slide section
1) Pass slide pipe through bearing 30 (integrated part of turn base) as illustrated in Fig 3A.
Assemble rubber washer and lock ring 30 to slide pipe as illustrated in Fig. 3B.
< Note > When rod is mounted to lock ring 30, the flat portion of lock ring 30
Bearing 30
2) Insert rod to which needle bearings 808 and 708 are assembled in advance, into the hole of slide pipe
through the hole of lock ring 30 as illustrated in Fig. 4B.
Rod
Needle bearing 808
Needle bearing 708
3) Assemble slide guide plate, slide guide support and slide guide by screwing hex socket head bolt M5 x 40
as illustrated in Fig. 5A and Fig. 5B.
The hex socket hd. bolts have to be fastened in
order of any of the above arrows. Not fasten them in random order.
has to be faced as illustrated in Fig. 4B.
Fig. 3A
Front cover
Fig. 4A
Slide guide plate
Slide guide support
Slide guide
Hex socket
hd. bolt M5 x 40
Fig. 5A
Bearing 30
Needle bearing 808
Needle bearing 708
Stop ring
Rod
View from front cover side
Turn base
Front cover
Rubber washer
Lock ring 30
Fig. 3B
Flat portion
Lock ring 30
Sliding pipe
Not screw hex socket head
bolt M5 x 6 in this process.
Fig. 4B
Assembled parts for sliding the
slide pipe
View from front cover side
Fig. 5B
P 5 / 13
Advertisement
