Advertisement
R
epair
3. Assemble link plate by fastening hex socket
head bolt M6 x 20 as illustrated in Fig. 13E.
And then, take off round bars which were
inserted for blocking compression spring 28
and spring holder, as illustrated in Fig. 13D.
Hex bolt M10 x 105
Hex socket head
bolt M6 x 20
< 5 > Adjusting the saw blade's angle
1. 0° bevel and miter angle (right angle)
Push the motor section to the nearest position
to guide rule, and fasten screw M6 x 20 to secure
the motor section in the above position.
Loosen lever 125 to the direction indicated
with arrow as illustrated in Fig. 14A.
Hex bolt M8 x 50
Turn hex bolt M8 x 50 two or three revolutions
counterclockwise so that the motor section tilts
the right.
Adjust the saw blade's right angle as illustrated in
Fig. 14C.
After adjusting, fasten hex bolt M8 x 50 again.
Round bars for blocking
compression spring 28 and
spring holder
Fig. 13E
Link plate
Lever 125
Screw M6 x 20
View from lever 125 side
Fig. 14B
Adjusting
bevel angle
Fig. 13D
Saw blade
Turn base
1R208
"90 degree set square"
Fig. 14C
P 11 / 13
Fig. 14A
Turn base
Adjusting
miter angle
Advertisement
