Mitsubishi Diamond Plus 93SB Service Manual page 23

DISASSEMBLY
• Before you disassemble the set, turn off power and pull out the power plug.
• Use the appropriate screwdriver that fits the screw. If you use screwdriver that does not fit, you may break
the screws.
• Assembly is the opposite process of Disassembly.
• Carefully discharge the CRT anode by shorting it to ground before removing anode cap.
Revolving Stand ASSY
1. Turn the monitor CRT face down on a clean static free surface to prevent scratching CRT face.
2. Remove the screw (PL-CPTS*3*10*15BF) and remove by pulling up the Hooks and lifting the Revolving
stand Assy up to the side.
Screw (PL-CPTS*3*10*15BF) HOOK
Revolving Stand Assy
Cabinet Back
1. Remove the two screws (PL-CPTS*4*16*15BF) and unlock the two hooks.
Hook
Screws (PL-CPTS*4*16*15BF)
3-1