General - Insignia NS-55D420NA16 User Manual

NS-55D420NA16 Insignia 55" 1080p 60Hz LED TV
Problem Solution
Trouble
• See instructions and a table of
programming
common codes in
your existing
page 80.
universal
• Codes are subject to change. For
remote
up-to-date codes, go to
control.
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries.
• Refer to the User Guide that
accompanied your universal remote
control and contact the manufacturer
if problems persist.

General

Problem Solution
No power.
• Make sure that the power cord
• Unplug the power cord, wait 60
• Other devices (for example, a
"No signal"
• Press INPUT and make sure that
error message is
displayed.
• If you are using a cable or
After Auto
• Reception can vary by channel
Channel Search,
there are no
channels.
• Make sure that the antenna or
• Try replacing the cable between
"Legal notices" on
is plugged into a working
outlet.
seconds, then plug the cord
back in and turn on your TV.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
you have selected the correct
input for the device or service
you are trying to use.
satellite box, use the remote
that came with that box to
change channels.
depending on the broadcast
power level of a given station.
Contact your cable or satellite
TV provider.
cable/satellite TV is connected
securely to your TV.
the antenna/cable or
cable/satellite box and your TV.
www.insigniaproducts.com
Problem Solution
When I press
• Turn on the device. Your TV
INPUT, I cannot
automatically detects and
select my
displays which video jacks have
device (it is
devices connected to them
grayed out).
when the devices are turned on.
• Turn off Auto Input Sensing. See
"Turning Input Sensor on or
on page 66.
One or more
• Make sure that the channels are
channels do not
not blocked. See
display.
parental control
page 59.
• Make sure that the channels are
not hidden. The channel may
have been deleted from the
channel list. You can tune to the
channel by pressing the
number buttons or you can add
the channel back to the channel
list. See
page 56.
• If you are using a cable or
satellite box, use the remote
that came with that box to
change channels.
• Press INPUT and make sure that
you have selected the correct
input for the device or service
you are trying to use.
• If you are using an antenna, the
digital channel signal may be
low. To check the digital
channel signal strength, see
"Checking the digital signal
strength" on page 57.
Password is lost.
• Enter 9999 to access parental
controls, then set a new
password. See
changing the
page 58.
Some settings
• If a setting is grayed, the setting
cannot be
is not available in the current
accessed.
video input mode (for example
TV mode). Change to a different
video input source. See
"Selecting the video input
source" on page 38.
TV cabinet
• When the TV is in use, the
creaks.
temperature rises naturally and
may cause the cabinet to
expand or contract which can
cause a creaking noise. This is
not a malfunction.
off"
"Setting
levels" on
"Hiding channels" on
"Setting or
password" on
73