Reference Section - Ada MP-1 CLASSIC Owner's Manual

ADA MP-1 Classic owner's manual

REFERENCE SECTION

FRONT PANEL FUNCTIONS
CLIP
INPUT
OUTPUT LEVEL
LED DISPLAY
PLAY MODE FUNCTIONS
BANK-UP/BANK-DOWN
0 THRU 9
MIDI CHNL
INTERNAL PRGM
MIDI PRGM
EDIT MODE FUNCTIONS
Places the MP-1 CLASSIC into Edit mode. The display reads "Edit" until a parameter is
selected. Display then shows the value of the selected parameter Use the
set the value of the selected parameter. If you decide not to edit the current Program, but
you've already pressed the EDIT button, you may exit the Edit mode by pressing EDIT again.
Note: A flashing EDIT LED indicates that the program has been changed. A solid EDIT LED
indicates that the program has not been changed.
VOICING
MASTER
BASS
MID
TREBLE
PRESENCE
NOISE GATE
CHORUS DEPTH
EFFECTS LOOP
STORE
Monitors signal level at different points in the circuit. To prevent
unwanted clipping. set levels so LED's light only during largest
transients. Note: Very short transients may not always trigger
the Clip LED's.
Accepts instrument level 1/4" phone jack.
Sets volume without affecting tone or amount of distortion
Displays selected program number. MIDI channel number, or
mapped program number in play mode. Displays selected
parameter's current value in edit mode.
Change the bank number (0 to 12) by using these buttons. After
bank selection, you must select the "ones" digit using the
buttons labeled (0 to 9) to exit bank select mode
Selects the "ones" digit of the program number.
Selects the MIDI channel Edit mode. Use
select MIDI channel 1 to 16, ALL (OMNI) or OFF.
Puts the MP-1 CLASSIC in INTERNAL PRGM mode (selects
the User program storage register).
Puts the MP-1 CLASSIC in MIDI PRGM mode (selects the MIDI
Map storage register).
Selects the preamp voice (distorted tube, clean solid state, etc.)
overdrive 1&2 Adjusts the amount of gain.
Adjusts the overall level for the program.
Adjusts the amount of low-frequencies ± 12dB.
Adjusts the amount of mid-frequencies ±12dB.
Adjusts the amount of high-frequencies ±12dB.
Adjusts the amount of high-mid-frequencies ±12dB.
Adjusts the NOISE GATE threshold (0 = OFF).
Adjusts chorus sweep depth and sweep rate
(depth of 0 = OFF).
Selects Effects Loop IN or OUT.
Places the MP-1 CLASSIC into Store mode. Used to store the
current Program or edited program (working registers) to any
Internal Program number. Press STORE button followed by a
Program number. LED indicates Store mode is engaged. LED
turns off when storage is complete. It you decide not to store
the current program. but you've already pressed the STORE
button, you may exit the Store mode by pressing STORE again.
The STORE mode is also used for the BANK-UP + digit hidden
commands (see below)
Page 14 of 18
and V arrows to
Λ
and V arrows to
Λ