RADIUS Type
RADIUS Server
Authentication
Port
Shared Secret
Session Timeout
Accounting
Accounting Port
IV-3-3-2. Internal Server
below used when "Internal" is selected for "RADIUS Type" in the "Wireless
Settings" "RADIUS" "RADIUS Settings" menu.
To use RADIUS servers, go to "Wireless Settings"
select "MAC RADIUS Authentication"
Authentication" and select "MAC RADIUS Authentication" (see
IV-3-1-3. & IV-3-2-3).
Select "Internal" to use the access point's
built-in RADIUS server or "external" to use an
external RADIUS server.
Enter the RADIUS server host IP address.
Set the UDP port used in the authentication
protocol of the RADIUS server. Value must be
between 1 – 65535.
Enter a shared secret/password between 1 –
99 characters in length. This should match the
"MAC-RADIUS" password used in IV-3-1-3-6 or
IV-3-2-3.
Set a duration of session timeout in seconds
between 0 – 86400.
Enable or disable RADIUS accounting.
When accounting is enabled (above), set the
UDP port used in the accounting protocol of
the RADIUS server. Value must be between 1 –
65535.
The access point features a built-in RADIUS
server which can be configured as shown
62
"Security" and
"Additional
AP Mode