Iv-6-4. Wps - Edimax CAP1200 User Manual

IV-6-4. WPS

Wi-Fi Protected Setup is a simple way to establish connections between WPS
compatible devices. WPS can be activated on compatible devices by pushing a
WPS button on the device or from within the device's firmware/configuration
interface (known as PBC or "Push Button Configuration"). When WPS is
activated in the correct manner and at the correct time for two compatible
devices, they will automatically connect. "PIN code WPS" is a variation of PBC
which includes the additional use of a PIN code between the two devices for
verification.
Please refer to manufacturer's instructions for your other WPS
device.
WPS
Product PIN
Push-Button WPS
WPS by PIN
Check/uncheck this box to enable/disable WPS
functionality. WPS must be disabled when
using MAC-RADIUS authentication (see
IV-6-2-3-6. & IV-6-5).
Displays the WPS PIN code of the device, used
for PIN code WPS. You will be required to enter
this PIN code into another WPS device for PIN
code WPS. Click "Generate PIN" to generate a
new WPS PIN code.
Click "Start" to activate WPS on the access
point for approximately 2 minutes. This has the
same effect as physically pushing the access
point's WPS button.
Enter the PIN code of another WPS device and
click "Start" to attempt to establish a WPS
connection for approximately 2 minutes.
173
Edimax Pro NMS