Cord Instructions; Wine Cellar Installation - Vinotemp VT-34-2ZONE Owner's Manual

For your protection, this unit should be
properly grounded. Unit is equipped with a 3-
conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in
combination with a properly connected
grounding-type outlet as shown in figure A.
It is not recommended to use this wine cellar
with an extension cord or power board. Please
ensure that the appliance is plugged directly
into the electrical outlet.

WINE CELLAR INSTALLATION

• Remove all exterior and interior packaging before use.
• Check to be sure you have all of the parts and 1 owner's manual.
• Place your wine cellar on a flat, dry surface that is strong enough to
support the unit when fully loaded.
• When positioning the cooler, leave a minimum of 6 inches at the
back of the cooler, 10-12 inches on each side of the cooler, and
unlimited clearance on top. This will ensure proper air circulation.
• This unit is designed to be free standing only. It is not designed to
be installed under a counter, inside a cabinet, or in any location that
does not allow the proper clearances on all sides, as stated above.
• Do not place heavy objects on top of the unit.
• Unit is not designed for installation in a garage or basement.
• Do not place the unit in direct sunlight or near sources of heat.
Extreme hot and cold ambient temperatures may cause the unit not
to perform properly or increase electrical consumption.
• Do not place the unit next to a major appliance that emits large
amounts of heat, such as a dishwasher, microwave, oven, etc.
• Do not plug unit into the same outlet as a refrigerator or microwave.
• Before connecting the appliance to the power source, let it stand
upright for approximately 24 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth
before first use.
8

CORD INSTRUCTIONS

W W W . V I N O T E M P . C O M