Cord Instructions; Beverage Cooler Installation - Vinotemp VT - DRAW2WBC Owner's Manual

2 drawer wine & beverage cooler

Hide thumbs

Table Of Contents

Table of Contents

For your protection, this unit should be properly

grounded. Unit is equipped with a 3-conductor

cord set that has a molded 3-prong grounding-

type plug, and should be used in combination

with a properly connected grounding-type outlet

as shown in figure A.

It is not recommended to use this beverage

cooler with an extension cord or power board. Please ensure that the

appliance is plugged directly into the electrical outlet.

BEVERAGE COOLER INSTALLATION

 Remove the exterior and interior packaging before use.

 Check to be sure you have all of the parts and 1 owner's manual.

 Place your beverage cooler on a flat, dry surface that is strong enough

to support the unit when fully loaded.

 Do not place heavy objects on top of the unit.

 Unit is not designed for installation in a garage, basement, or any

other location where a controlled ambient environment between 60°

and 90°F cannot be maintained.

 Do not place the unit in direct sunlight or near sources of heat.

Extreme hot and cold ambient temperatures may cause the unit not to

perform properly or increase electrical consumption.

 Do not place the unit next to a major appliance that emits large

amounts of heat, such as a dishwasher, microwave, oven, etc.

 Do not plug unit into the same outlet as a refrigerator or microwave.

 Before connecting the appliance to the power source, let it stand

upright for approximately 2 hours. This will reduce the possibility of a

malfunction in the cooling system from handling during transportation.

 Clean the interior surface with lukewarm water using a soft cloth

before first use.

 Do not lift unit by door handle

 Be sure front grill is free of obstruction. Obstructing free airflow can

cause the unit to malfunction and will void the warranty.

 Failure to clean the condenser every six months can cause the unit to

malfunction.

 Allow unit temperature to stabilize for 24 hours before use.

 To level your appliance, adjust the front legs at the bottom of the

appliance.