Cord Instructions; Wine Cellar Installation - Vinotemp VT-58 Owner's Manual

Hide thumbs Also See for VT-58:

Instruction manual (14 pages)

Owner's manual (16 pages)

Table Of Contents

Table of Contents

For your protection, this unit should be properly

grounded. Unit is equipped with a 3-conductor

cord set that has a molded 3-prong grounding-

type plug, and should be used in combination

with a properly connected grounding-type outlet

as shown in figure A.

It is not recommended to use this wine cellar

with an extension cord or power board. Please ensure that the appliance

is plugged directly into the electrical outlet.

WINE CELLAR INSTALLATION

• Remove the exterior and interior packaging before use.

• Check to be sure you have all of the parts, including an accessory kit

and 1 owner's manual.

• Place your wine cellar on a flat, dry surface that is strong enough to

support the unit when fully loaded.

• This unit is designed to be built-in (fully recessed) or free standing.

• For freestanding installation, 6" of space at the back, 10-12" of space

on each side, and unlimited clearance at the top of the wine cooler are

suggested to ensure proper air circulation to cool the compressor and

condenser. Do not place underneath a table, counter top, or anything

of the sort as this will not allow for proper air circulation.

• Do not place heavy objects on top of the unit.

• Unit is not designed for installation in a garage or basement.

• Do not place the unit in direct sunlight or near sources of heat.

Extreme hot and cold ambient temperatures may cause the unit not to

perform properly or increase electrical consumption.

• Do not place the unit next to a major appliance that emits large

amounts of heat, such as a dishwasher, microwave, oven, etc.

• Do not plug unit into the same outlet as a refrigerator or microwave.

• Before connecting the appliance to the power source, let it stand

upright for approximately 24 hours. This will reduce the possibility of a

malfunction in the cooling system from handling during transportation.

• Clean the interior surface with lukewarm water using a soft cloth

before first use.